Form No. SRCEM-0314
12
MAiNteNANCe
Replacing the heat Lamps
Use the following procedure to change the halogen heat lamps
in SRBW-1, SRGBW-1, and SRSSBW-1 models.
Use only Genuine hatco Replacement Parts when service
is required. Failure to use Genuine hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine hatco Replacement Parts
are specified to operate safely in the environments in which
they are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow them
to operate safely in hatco equipment.
Use only low pressure halogen light/heat lamps that meet
or exceed National Sanitation Foundation (NSF) standards
and are specifically designed for food holding areas.
NOTE: Hatco halogen heat lamps meet NSF standards for food
holding and display areas.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Holding one hand under the lamp cover, use a screwdriver
to remove the two screws that secure the lamp cover in
position.
NOTE: The glass shield inside the lamp cover is loose and will
drop down with the lamp cover. Make sure to support
the lamp cover with one hand during removal of the
screws.
Do not touch halogen heat lamps with bare skin. Oils from
the skin will cause premature failure of the lamps.
3. Remove the old heat lamp from the lamp holder. The heat
lamps are held in position with spring steel contacts on
each side of the lamp holder. To remove:
a. Grasp the old heat lamp bulb and carefully push it into
one of the spring steel contacts in the lamp holder to
release it from the opposite side spring steel contact.
b. Pull the free end of the lamp down and remove the lamp
from the lamp holder.
NOTICE
WARNING
4. While wearing gloves or using other protection, install the
new heat lamp into the lamp holder. To install:
a. Grasp the new heat lamp and carefully push one end
into the spring steel contact in one side of the lamp
holder.
b. Lift the other end of the lamp into position against the
spring steel contact on the opposite side of the lamp
holder (opposing pressure from the spring steel contacts
will hold the lamp securely in the lamp holder).
5. Position the lamp cover with glass shield over the heat
lamp and secure using the two screws.
Replacing a Heat Lamp
The following replacement halogen heat lamps are available
from the factory or a Hatco authorized Parts Distributor.
Standard Wattage
150 W, 120 V
02.30.150.00
150 W, 230 V (CE)
02.30.151.00
high Wattage
300 W, 120 V
02.30.117.00
300 W, 230 V (CE)
02.30.126.00
Lamp
Cover
Screw
Lamp
Lamp
Holder
Summary of Contents for SeRv-Rite SRB Series
Page 86: ...Form No SRCEM 0314 86 NOteS ...
Page 87: ...Form No SRCEM 0314 87 NOteS ...
