8
Form No. DCSm-0214
INSTALLATION
English
General
Use the following information and procedures to install a
Decorative Carving Station.
ELECTRIC SHOCK HAzARD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
FIRE HAzARD:
• Locate unit a minimum of 1″ (25 mm) from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
1. Remove the unit from the carton.
2. Remove tape and protective packaging from all surfaces of
unit.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPoRTANT oWNER INFoRmATIoN
section for
details.
3. Place the unit in the desired location. For countertop
mounted models, refer to the “Installing Countertop
mounted models” procedure in this section.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
Avoid areas that may be subject to active air
movements or currents (i.e., near exterior doors,
exhaust fans/hoods, air conditioning ducts, etc...).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under the
Hatco warranty. Contact the manufacturer of the
countertop material for application information.
WARNING
CAUTION
NOTICE
Installing Countertop Mounted Models
(DCS400-1CM)
1. Cut a 3-1/4″ (85 mm) in diameter opening in the countertop.
NOTE: The countertop cannot be thicker than 2-1/2″ (64 mm).
2. Lower the lamp post assembly into the countertop cutout.
3. From underneath the countertop, align the clamp plate
holes with the studs.
4. Secure the unit to the countertop using the four washers
and nuts.
5. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. See the
SPECIFICATIoNS section for details.
Installing DCS400-1Cm model
Studs
Clamp Plate
Washers
Nuts
Cutout Diameter
3-1/4″ (85 mm)
Countertop
