11
Front protective cover 1
Always fit the front protective cover when no lens is attached to
protect the mirror and interior.
Attach the cover as you would a lens, see below. To remove, turn
the cover (bayonet fitting) in the direction of the arrow and lift
it out.
The front protective cover can only be removed when the camera
is fully wound.
Rear cover Multicontrol 2
Always fit the rear cover Multicontrol when no back is attached
to protect the auxiliary shutter. Attach the cover as you would a
back, see below.
To remove, depress the top part, tilt the cover backwards, and
lift it off. See later sections on the other uses of the Rear cover
MultiControl.
Opening the focusing hood 3
Lift the lid by firmly gripping the tab on its rear edge, and swinging
it up to a vertical position. The hood unfolds automatically and
locks in the open position.
Camera Body
This section describes the basic operations. Follow
the instructions step-by-step to avoid damaging
the equipment. Check that the winding crank on the
right hand side of the camera is locked thus ensur-
ing that the camera is fully wound. If the crank is not
locked, rotate it clockwise until it does lock, thereby
winding the camera.
2
501
503
CWD
3
2
1
