16
Face Plate Installation and Removing
(Refer to Fig. 13)
1. Unplug the lathe from the power source.
2. Mount the face plate to the work piece.
3. Install the face plate onto the spindle thread and turn it clockwise
4. Insert the lock rod (A) into the hand wheel hole. Hold the rod and tighten the face plate
with the face plate wrench (B).
5. Tighten the set screw on the face plate when you work with the lathe in reverse rotation.
6. Reverse these directions to dismount the Face Plate.
B
A
Fig .13
Tailstock Quill
Loosen the Tail Stock Quill Locking Handle, rotate the Tail Stock Hand Wheel to the
desired Tail Stock Quill position, and then tighten the Tail Stock Quill Locking Handle.
Live Centers Installation/Removing
1. Make sure the taper of the center and the quill hole are clean and free of debris. Push
the center into the quill hole.
2. To remove the center from the tailstock, loosen the tailstock quill locking lever and move
the quill out by turning the quill hand wheel until the quill end is almost inside the tailstock,
then the center can be taken out by hand.
