9
Legs Installation
(Refer to Fig. 2)
1. Lift the lathe off the pallet by using a hoist or forklift. Place it on a table or workbench with
sufficient clearance which allows for the support legs to be attached from underneath.
2. Attach the legs to the bed with 12mm hex head screws (A). Then firmly tighten the
screws.
3. After firmly securing the legs to the lathe, carefully lower the lathe onto the floor.
4. Install four leveling feet (B), and tighten four nuts(C) against the legs. (These can be
adjusted later.) Make sure that the lathe does not rock.
Fig.2
Tool Storage Bracket
(Refer to
Fig. 3)
The tool storage bracket (D) can be mounted to the left end of the lathe. Use two 12mm
head cap screws (A) with flat (C) and spring washers (B) to secure it to the lathe.
Fig.3
A B C
D
A
C
B
