15
Tool Rest Base (Banjo)
The Banjo is designed with a cam-lock system, it can slide along the bed freely when
unlocked. Loosen the locking handle and move the Banjo to the desired place. Lock the
lever firmly after adjustment
.
Tool Rest
The 14
″
tool support is provided with your lathe as standard equipment. It is designed
to allow the adjustment for height and angle. Loosen the locking lever to raise or lower
the tool rest and angle it to the work. Tighten the handle before operating the Lathe.
The locking lever can be inserted into one of three holes on the tool rest base.
HeadStock and TailStock
Both headstock and tailstock can slide along the bed. Loosen the locking lever and
move the Headstock or Tailstock to a desired place. Tighten the lever firmly after
adjustment.
CAUTION
: Always Unplug the lathe from the power source before adjusting the
headstock.
Spur Centers Installation/Removing
(Refer to Fig. 12)
1. Unplug the lathe from the power source.
2. Make sure the taper of the center and the spindle taperred hole are clean and free of
debris. Then push the center into the spindle taperred hole for installation.
3. To remove the center, insert the knockout rod into the back hole in the end of spindle
and tap the center end out.
Fig .12
