![background image](http://html1.mh-extra.com/html/harvest-tec/547c/547c_installation-manual_2103716005.webp)
5
Installation of the Applicator
1. Installation of Tank and Saddle
a. Locate the left saddle leg, 001-4703XL, and mount to left side
sheet of baler using two ½” x 1-1/2”
hex bolts, ½” lock washers, and ½” flat washers. Do not fully tighten.
b. Locate the right saddle leg, 001-
4703XR, and mount to right side sheet of baler using two ½” x 1-
1/2” hex bolts, ½” lock washers, and ½” flat washers. Do not fully tighten.
c.
Roll Belt 180/460 and RB465 Installation only!
Locate the two anchor extension brackets, 001-
4703XAX, and attach one extension bracket to the outside of each leg with two ½” x 1-1/2” hex
bolts, ½” lock washers, and ½” flat washers.
d. Locate the anchor bracket, 001-4703XA, and attach to the side of the extension bracket, 001-
4703XAX for 4 X 6 balers (or 001-4703XR and 001-
4703XL for other balers) using two ½” x 1-
1/2” hex bolts, ½” flat washers, ½” lock washers, and ½” hex nuts. Do not fully tighten. Note that
001-4703XA should be positioned so it is angled toward the round pipe that runs across the width
of the baler behind the legs. Repeat procedure for the opposite side.
e. Locate the u-bolts, 001-4703XAB, and attach the 001-4703XA brackets to the round pipe running
across the baler. Tighten the u-bolts evenly. **
Due to minimal clearance between the anchor
bracket and the side sheet, use a deep socket and long extension on a ratchet to tighten the u-
bolts.
f. With the u-bolts, 001-4703XAB, securely tightened around the round pipe, tighten the bolts
connecting the anchor brackets, 001-4703XA, to the saddle legs, 001-4703XL & 001-4703XR.
g. Tighten the hardware attaching the saddle legs, 001-4703XL & 001-4703XR, to the side sheets of
the baler.
h. Install the tank assembly (tanks, straps, handrail, and saddle pan) on the legs. Secure the saddle
pan, 001-
4703X, to the saddle legs with ½” flat washer, ½” lock washer, and ½” hex nut from the
bottom side in four locations. Tighten hardware.
The following pages contain additional illustration for mounting on your baler
4 X 5 pg 7
4 X 6 pg 8
5 X 5 pg 9
5 X 6 pg 10
Summary of Contents for 547C
