![background image](http://html1.mh-extra.com/html/harvest-tec/547c/547c_installation-manual_2103716019.webp)
19
Mounting Rear Pump Plate Support for the 5 x 6 Baler
1. Locate the baler door support bracket. This will be to the left of the Mounting Plate (001-4646C).
2.
Use two 3/8” x 1” hex bolts, flat washers, lock washers, and nuts to secure Pump Plate Bracket
(001-4703XF) to back side of Pump Mounting Bracket (001-4646C). Use holes
3 and 4
as
designated in Figure 2 on the Pump Plate Bracket (001-4703XF). Slide the Pump Plate Bracket
(001-4703XF) so it touches the door support bracket.
3. Place a level on top of the Mounting Plate (001-4646C) to make sure it is level. Using the Pump
Plate Bracket (001-4703XF) as a guide mark holes (
A and E)
on the door support bracket.
Remove brackets (001-4703XF and 001-4646C) for drilling. Center punch holes and drill with a
7/16” drill bit.
4. Once holes are drilled secure (001-
4703XF) to door support bracket with two 3/8” x 1” hex bolts,
flat washers, lock washers, and nuts.
5. Attach pump mounting bracket back onto brackets (001-4703XF and 001-
4703XE) with 3/8”
hardware.
6. Attach pump plate with pumps onto Mounting Plate (001-
4646C) bracket with 3/8” x ¾” flange bolts
removed earlier.
7. Install Pump Controller (006-5672
) into pump plate using 5/16” flat washers, lock washers, and
nuts.
The Pump Controller and pump heads must be pointing down. Failure to mount the pump plate
assembly in this specified direction will void all warranty of the Pump Controller and pumps.
Summary of Contents for 547C
