4
INSTALLATION OF APPLICATOR
1. INSTALLATION OF TANK, MOUNTING BRACKETS, GAUGE, & DRAIN/FILL LINE
Locate the tank base bracket (001-4442U). This bracket will mount on the front of the baler is show
below. Depending on the year of the baler only two of the required three holes may be premade on
the baler. Mark and drill two 1/2” holes (one per side) if necessary. Take care to check behind the
area
before drilling. The bracket will be secured on each side with three 1/2” x 1 – 1/4” hex bolts, six
flat washers, three lock washers, and three hex nuts. Secure the left side of the baler first. Slide the
supplied shims (001-4442US), if necessary, between the tank base bracket and the baler side wall if
necessary. The shims need to be installed to prevent the balers side wall from moving in once the
tank base bracket hardware is tightened. Tighten all hardware.
001-4442U
Front of Baler
A
Summary of Contents for 442U
Page 16: ...16 NOTES...