10/6/10
888-2629-200
5-29
WARNING: Disconnect primary power prior to servicing.
Section 5 Maintenance and Alignments
Maxiva ULX COFDM Series
Figure 5-16 RF Output Coaxial Line Connection
STEP 7
Lift the output coax line (the line above the coupler) upward taking
care to disconnect and support the inner conductor. Lift the inner
and outer upward through the top of the cabinet. Store the coaxial
line section in a safe location.
STEP 8
Loosen the clamp that holds the hybrid combiner reject port elbow
in place while supporting the back to back elbow assembly and the
reject load. Lower the elbow (see Figure 5-19 on page 5-31) to
disconnect the inner conductor bullet. Lift the back to back elbows
and reject load (with attached coolant hoses) up and out of the way.
It can be temporarily tied up out of the way with a small rope or
with heavy duty tie wraps.
STEP 9
Remove the bolt from the RF support bracket at the bottom of the
cabinet (13 mm wrench).
The bolt is shown in Figure 5-17 on page 5-
30.
Clamp
Summary of Contents for Maxiva ULX COFDM Series
