AL815CC, AL825, AL825CC, AL835 Hybrid Installation & Owner's Manual 2017
25
TEC00037 2016FEB20 P/N: 630-00053 Rev A
SECTION 2 : INSTALLER
Installation
Figure 25-2
3. Open the enclosure and insert the wires through
the grommet.
Pull enough wire through to be able
to manipulate the ends. (Save screws to seal the
enclosure at the end.)
[Figure 25-1]
SAVE FOR
STEP #4
4. Pull off the individually pre-stripped insulation
ends.
Twist each end of the wires individually to keep
all the wire strands together.
[Figure 25-2
]
5. Insert each color wire into their appropriately-
labeled terminal.
Tighten each wire down after
insertion.
[Figure 25-3]
Test each wire by pulling it moderately to make sure
that it is secure in the contact block.
Figure 25-1
Figure 25-3
