| www.harmar.com | 800-833-0478
12
SECTION 2 : INSTALLER
Preparation
Installation Overview
WARNING
Never attempt to pick up the lift from the box, ground or on/off a
vehicle alone.
Two people should work together to place this lift inside a vehicle.
If only one person is available, please follow the short disassembly
procedure below.
1.
Choose a Location.
Place
base and leg extensions in the
far corner of the truck bed.
Driver's Side
Base Required
Passenger Side
Base Required
FRAM
E
FRAME
FR
A
ME
Overview of Recommended Installation Procedure
Examine under the truck where
three to five holes will need to
be drilled. (Number of holes
depend on payload)
Wherever possible, incorporate
the frame rails of the truck. This
is a requirement when lifting
heavier chairs and scooters.
2. Install Vehicle Wiring Harness.
Installing the wiring harness first will allow powered movement of the lift,
aiding in the installation. [See page 13]
3. Install Lift Components.
Install power base assembly
onto base mounted to truck
bed. [See pages 19 ]
Install vertical post so that
bottom horizontal bar just clears
truck side wall.
Install lifting arm using bolts
provided.
Driver's Side
Base Shown
