Harman SoundCraft Vi3000, User Manual

Page: 168 / 202

Vi3000 USER MANUAL
®
16.9 16.9: MENU > SETTINGS
16.9: MENU > SETTINGS
Set Meter In
Point
Determine the metering
point for the input chan-
nel level meters.
There are four choices for the input meter tap, from
left to right: After the analogue mic gain (before digital
trim and filters); after the digital trim and filters (before
the Gate/EQ/Dynamics); after the Gate/EQ/Dynamics
(before the fader); after the fader.
Graphic EQ
Large/Small
Mode
Range Low Range High
Choose between Large
and Small Graphic EQ
control modes.
Choose ‘Large’ 30-fader mode for fast access on multiple
faders, at the expense of access to the input faders, or
choose ‘Small’ (eight output faders) mode when access
to input faders must be retained at all times. Frequency
bands can be scrolled in banks of four or eight bands,
using the Output Fader page buttons.
Small GEQ Large GEQ
Set Delay Units
Change the units used
in input, output, and
monitoring delay adjust-
ments.
You can choose between milliseconds, metres, or feet
and inches.
EQ bandwith
units
Range Low Range High
Choose the the unit
for bandwidth controls
in the EQ sections
throughout the console
Selected either Octaves or Q-factor (defined as the ratio
of frequency to bandwidth). The direction of the control is
reversed between the two settings: In Q mode, clockwise
narrows bandwidth, in Octaves mode, clockwise widens
bandwidth.
Q-Factor
Octave Band-
width
Enable NEXT
and LAST
Inactive Active
Enable the [NEXT] and
[LAST] cue list naviga-
tion buttons nearest the
operator. [NEXT]/
[LAST] at
front of desk
disabled
[NEXT]/
[LAST] at
front of desk
enabled
DANTE / MADI
Select
Range Low Range High
Switch MADI/Dante
input between MADI
and Dante sources.
See hardware reference 4.2 for operational details.
Dante
selected
MADI
selected