28
3-90-07205R26_10/14
Starting A Fire Automatically
1.
MIN. TeMP. Selector to “OFF”.
This resets the control
in addition to turning it off.
2.
Clean Burnpot
with scraper, if necessary. This is usually
a weekly maintenance procedure. Cleaning the burn pot
with the scraper with a small amount of new fuel in the
bottom is not a problem. First, scrape the ashes on the
front of the burn pot into the ash pan. Then scrape the
hole grid surface downward into the burn pot. When the
stove is ignited these scrapings will be pushed out by the
feeder.
The illustration at left shows the hopper swing plate open
for easy access to the burn pot. The burn pot can also be
reached through the firebox door.
NOTE: To minimize the amount of stress placed on the
hopper swing plate hinges, opening of the hopper swing
plate should be done with the least amount of fuel in the
hopper as possible.
3.
Fill Hopper
with pellets. When filling the hopper check
for excessive fines in the bottom of the hopper. Fines
are small pieces of broken pellets (sawdust). Fines do
not flow easily and often build up on the hopper funnel
bottom angles. These fines can be pushed into the
feeder opening and then fill the hopper with pellets. As
the system works, they will be burned.
4.
If Starting After an empty Hopper, Turn Feed Adjuster
to “TeST”
(for one 60 second cycle). This will feed pellets
into the auger tube and also allow you to check the motors
for operation.
NOTe: The auger motor will not operate
with any of the doors open.
5.
Turn Feed Adjuster to #4.
If this is your first fire or you
are trying different pellets, set the feed adjuster to #4, This
is an average number for most pellets and may need to
be adjusted for your particular fuel. After you know a feed
rate setting that works well for your application, use that
setting.
NOTE: you know your feed rate is too high when: The
overheat safety feature is energized each time the
heating zone demand turns off during a high burn. OR,
if unburned or partially burned pellets are found in the
ash pan. (This may also be an indication of a burn pot
in need of scraping.)
6.
Flip the Igniter Switch up
into the “AUTO” position.
7.
Turn the MAX. TeMP. dial
on the control board to the
desired temperature. This setting must always be at least
5° F. higher than the MIN. TEMP. setting.
Automatic Ignition
Scrape burnpot to remove any carbon
build-up that may have occured
HOT WHIle IN OPeRATION. KeeP CHIldReN,
ClOTHING, ANd FURNITURe AWAY. CONTACT MAY
CAUSe SKIN BURNS.
WARNING
!
Summary of Contents for PB 105
Page 51: ...3 90 07205R26_10 14...
