Harman Martin MAC Aura PXL, User Manual

Page: 41 / 46

Control panel menus
41
PERSONALITY
(continued)
ERROR MODE
NORMAL
Enable error messages and warnings in
display
SILENT
Disable error messages and warnings in
display (the status LED will still light to
indicate fixture status if an error has been
detected or the fixture has a warning)
HIBERNATION
MODE
ON
Enable Hibernation Mode (light output set
to zero, all effect movement disabled)
OFF Disable Hibernation Mode
DEFAULT
SETTINGS**
FACTORY
DEFAULT
LOAD
ARE YOU SURE?
YES/NO Return all settings (except calibrations) to
factory defaults
CUSTOM 1
LOAD
ARE YOU SURE?
YES/NO
Load Custom Settings 1
SAVE
ARE YOU SURE?
YES/NO Save fixture’s current settings as Custom
Settings 1
CUSTOM 2
LOAD
ARE YOU SURE?
YES/NO
Load Custom Settings 2
SAVE
ARE YOU SURE?
YES/NO Save fixture’s current settings as Custom
Settings 2
CUSTOM 3
LOAD
ARE YOU SURE?
YES/NO
Load Custom Settings 3
SAVE
ARE YOU SURE?
YES/NO Save fixture’s current settings as Custom
Settings 3
INFORMATION
POWER ON TIME
TOTAL 0
...
XXX HR
Display hours fixture has been powered on
since manufacture (not user-resettable)
RESETTABLE
CLEAR
COUNTER?
YES/NO
Display hours fixture has been powered on
since last counter reset (user-resettable)
POWER ON
CYCLES
TOTAL 0
...
XXX HR
Display number of times fixture has been
powered on since manufacture
(not user-resettable)
RESETTABLE
CLEAR
COUNTER?
YES/NO Display number of times fixture has been
powered on since last counter reset
(user-resettable)
FW VERSION XX.XX.XX Displays currently active firmware version
RDM UID** 4D50.XXXXXXXX Displays fixture’s unique RDM ID
FAN SPEEDS**
HEAD FAN 1 ... 4,
BASE FAN 1 - 2
0 - XXX RPM
Scroll to display current speed of each
cooling fan (head and base)
TEMPERA-
TURES**
UI
...
AURA PIXEL
CURRENT / MIN /
MAX X C
Scroll through PCB temperature sensors,
then display current, minimum* and
maximum* temperature in °C of all PCBs
*Since fixture was last powered on
DMX LIVE**
RATE 0 - 44 HZ
DMX transmission speed in packets per
second
QUALITY 0 - 100% Percent of packets received
START CODE 0 - 255 Value of the DMX start code
STROBE
...
P3+
MODE AURA
XXX
Scroll to see values received on each DMX
channel
TEST**
TEST ALL BEAM DIMMER ... TILT
Run test sequence of all functions
To test a specific function, use Up/Down
buttons to scroll through functions. Press
Enter to pause and press again to restart
test sequence.
Press Menu button to exit test
TEST LEDS
BEAM DIMMER ... AURA V COLOR
WHEEL
Run test sequence of LEDs only.
To test a specific LED group, use Up/Down
buttons to scroll through groups. Press
Enter to pause and press again to restart
test sequence.
Press Menu button to exit test
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 6: Control menus