![background image](http://html1.mh-extra.com/html/harman/martin-exterior-projection-1000/martin-exterior-projection-1000_user-manual_3984864006.webp)
6
Exterior Projection 1000 User Manual
User documentation
Install, operate and service Martin products only as directed in their user manuals or you
may create a safety hazard or cause damage that is not covered by product warranties.
Keep this user manual for future use. Before installing, using or servicing this fixture,
check that you have the latest version of the user manual, available on the fixture’s Tech
Docs/Support page on the Martin website at http://www.martin.com. Martin user manual
versions are identified by the Revision letter given at the bottom of page 2.
Refer any operation not described in this user manual to Martin Global Service or an
authorized Martin service agent.
Follow the safety precautions listed below and observe all warnings in this manual and
printed on the fixture. Keep this user manual for future use.
Protection from electric shock
This fixture is IP66 rated. It is suitable for use in wet locations, but do not immerse it in
water or install it in a location where it may become submerged.
The fixture is a Class I product according to IEC 61140. Ensure that the fixture is
electrically connected to ground (earth).
Disconnect the fixture from AC power when the fixture is not in use.
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-fault (earth-fault) protection.
The circuit used to supply the fixture with AC power must include a power switch that is
easily accessible so that the fixture can easily be disconnected from power.
Shut down power to the entire installation at the main power distribution board and lock
out power before carrying out any installation or maintenance work.
Isolate the fixture from power immediately if any seal, cover, cable, connector or other
component is damaged, defective, deformed, wet or showing signs of overheating.
Contact Martin for any service operation not described in this user manual. Do not
reapply power until repairs have been completed
Before using the fixture, check that all power distribution equipment and cables are in
perfect condition and rated for the electrical requirements of all connected devices.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in order to
avoid a hazard.
Protection from burns and fire
Do not operate the fixture if the ambient temperature (T
a
) exceeds 45° C (113° F).
The surface of the fixture casing can reach up to 85° C (185° F) during operation. Avoid
contact by persons and materials. Allow the fixture to cool for at least 10 minutes before
handling.
Keep flammable materials well away from the fixture. Keep combustible materials (e.g.
fabric, wood, paper) at least 0.1 m (4 ins.) away from the fixture housing.
Ensure that there is free and unobstructed airflow around the fixture.
Do not illuminate surfaces within 1.5 m (4.9 ft.) of the front glass.
Do not stick filters, masks or other materials onto any optical component.
The fixture’s optical components can focus the sun’s rays, creating a risk of fire and
damage. Do not expose the front of the fixture to sunlight or any other intense light
source.
Summary of Contents for Martin Exterior Projection 1000
