Harman Martin Exterior Projection 1000, User Manual, Page: 7 / 60

Exterior Projection 1000 User Manual 7
Protection from eye injury
Do not stare directly into the light output. Ensure that persons are not looking directly into
the lamp when the fixture lights up suddenly. This can happen when power is applied,
when the fixture receives a DMX signal, or when certain control menu items are
selected.
Do not look at the light output with magnifiers, telescopes, binoculars or similar optical
instruments that may concentrate the light output.
Wear protective glasses and other PPE (personal protective equipment) when working
on or near the fixture.
The risk group distances given below apply to the light output from one fixture only. If
fixtures can be operated in combination, light intensity can increase and you should
consult a lighting professional for safety recommendations.
The Exterior Projection 1000 is classified into the following risk groups according to EN
62471 at the distances indicated:
At a distance of less than 0.2 m (7.9 ins.) from the fixture, the light output can potentially
cause eye or skin injury before an exposed person’s natural aversion responses (blink
reflex and reaction to skin discomfort) can protect them. At distances greater than 0.2m
(7.9 ins.), potential eye and skin injury hazards from the light output are normally
prevented by natural aversion reflexes.
Position the Exterior Projection 1000 so that persons cannot be exposed to the fixture’s
light output at less than 0.2m (7.9 ins.) from the fixture and so that prolonged staring into
the light output at less than 10 m (33 ft.) from the fixture is not expected.
Protection from injury
Fasten the fixture securely to a fixed surface or structure when in use. The fixture is not
portable when installed.
Ensure that any supporting structure and/or hardware used can hold at least 10 times
the weight of all the devices they support.
If suspending the fixture from a rigging truss, support it with two rigging clamps and
secure it with an additional attachment such as a safety cable that will catch it if a rigging
clamp fails. Check that the truss and all installation hardware are approved for the weight
that they will support.
Check that all external covers and installation hardware are securely fastened.
Do not operate the fixture with missing or damaged covers, shields or any optical
component.
Block access below the work area and work from a stable platform whenever installing,
servicing or moving the fixture.
In the event of an operating problem, stop using the fixture immediately and disconnect it
from power. Do not attempt to use a fixture that is obviously damaged.
Do not modify the fixture or install other than genuine Martin parts.