Harman DVC-500, Installation & Operating Manual

Page: 7 / 36

7
4 GLASS RE-
TAINER CLIPS
4 GLASS
RETAINER
BOLTS
GLASS
GLASS GASKET
DOOR
HINGE PINS
BRASS HANDLE
HANDLE BOLT
WOOD HANDLE
PAW BOLT
SET SCREW
Door Glass
* Rope the glass carefully to insure proper seal-
ing.
* Apply the rope exactly along the edge of the ex-
ternal face of the glass, not overhanging or pressed
too far in from the edge.
* Make sharp 90
o
turns at the corners.
* Tightly join the ends of the rope at the upper left
or right corner.
Glass Retainer Clips
* Use the glass retainer clips and screws supplied
in the door kit.
* Use a 1/8" Allen wrench to tighten the glass clips
to cast door with 10-24 x 3/8" screws supplied.
Paw Bolt
* The paw bolt should be turned into the door from
the inside approximately 14 turns.
* With the set screw removed, turn the brass elbow
onto the paw bolt approximately 5 turns, or until a
1/16" clearance is achieved between the elbow and
the door face (make sure to stop on the flat spot of
the paw bolt).
* The set screw on the brass elbow must be aligned
to contact the flat spot on the paw bolt, then tighten
using a 5/32" Allen wrench.
* After attaching the door handle, close and latch the
door by turning the handle to the six o'clock position.
During this process observe to see that the door rope
is being compressed properly.
* If it does not compress, loosen the set screw and
turn the paw bolt one additional turn into the door.
Repeat as required to insure a tight seal.
Door Assembly/Installation Tips