SALTBURN / DALBY SMOKE CONTROL ISSUE 2 06/07/2015
SALTBURN SMOKE CONTROL /
DALBY SMOKE CONTROL
WOOD BURNING STOVE
INSTALLATION AND USER INSTRUCTIONS
Read these instructions carefully before installation and use.
These instructions should be retained by the user for future reference.
Please note these instructions cover 2 models of stoves;-
The Saltburn Smoke Control (flat door version) and the
Dalby Smoke Control (curved door version)
The Saltburn / Dalby Smoke Control stove has a nominal heat output of 5kW and a
weight of 61 kg. The flue gas mass flow is 2.9 g/s for wood logs. The mean flue gas
temperature directly downstream of the flue spigot at nominal heat output is 233 degrees C.
The Saltburn / Dalby Smoke Control has been tested as a closed appliance and is capable of
intermittent operation.
WARNING
The stove must be installed to comply with Health and Safety at Work Act 1974,to British
Standard BS 8303 and to all local Building Regulations, including those referring to
National and European standards.
These need to be complied with when installing the appliance.
Ensure that the flue pipe diameter is not less than the 125mm diameter outlet on the
appliance.
There must not be an extractor fan fitted in the same room as the Saltburn / Dalby Smoke
Control.
If there is a possibility of disturbing asbestos during the installation it is necessary to take
the appropriate steps to protect the installer.
Fire cement is caustic and protective gloves should be worn.
The chimney must be swept and examined for soundness and suitability before the stove is
installed. Remedial action should be taken if required, seeking expert advice if necessary.
Where the chimney is believed to have previously served an open fire installation it is
possible that the higher flue gas temperature from a closed appliance may loosen deposits
that were previously firmly adhered, with the consequent risk of flue blockage.
