Enova 22xx All-in-One Presentation Switchers
19
Instruction Manual - Enova DVX-325xHD/22xxHD All-in-One Presentation Switchers
Enova 22xx All-in-One Presentation Switchers
DVX-2250HD/2255HD/2210HD
FIG. 3 displays the DVX-2250HD-SP.
FIG. 3
Enova DVX-2250HD-SP
Specifications
The following table lists the specifications for the Enova 22xx All-in-One Presentation Switchers:
DVX-2250HD/2255HD/2210HD Specifications
Power:
~100-240V, 50/60Hz
Power Consumption:
• 80 Watts typical without amplifier
• 85 to 90 Watts typical average with amplifier
• 30 Watts typical in low-power mode
Memory:
• 256 MB SDRAM
• 1 MB Non-volatile RAM (NVRAM)
• 4 GB Flash
Amplifier:
• 2 x 25W into 8 Ohms Class D stereo amplifier (capable of driving loads in the range of 2-8 ohms) (-SP
models only)
• 70V or 100V at 75W amplified variable mono audio (-T models only)
Integrated Controller:
Equivalent of an NX-2200 central controller on-board
Front Panel Components:
Program Port:
1 Type-B USB port that can connect to a USB port on a PC and access the NetLinx Studio program for
controller configuration.
USB Port:
1 Type-A USB port for connecting a mass storage device for loading .tkn files, reading or writing configuration
files and log files, or updating the firmware on the unit.
LEDs:
• LINK/ACT (green) - Link/Activity LED lights when the Ethernet cables are connected and terminated
correctly and blinks when receiving Ethernet data packets.
• STATUS (green) - Status LED blinks to indicate that the system is programmed and communicating properly.
• INPUT (yellow) - Input LED blinks to indicate that the Controller is receiving data.
• OUTPUT (red) - Output LED blinks to indicate that the Controller is transmitting data.
• ICSLAN (red) - ICSLAN LED blinks when the category cable to port 1 is connected and terminated correctly.
The LED also blinks when receiving LAN data packets.
• SERIAL (red/yellow) - 4 sets of LEDs indicate that the RS-232 ports (2-4) and RS-232/422/485 port (1) are
transmitting or receiving data.
• RELAYS (red) - 4 LEDs indicate relay channels 1-4 are active (closed) on Port 21.
• IR/SERIAL (red) - 4 LEDs indicate that IR/Serial channels 1-4 are transmitting control data on Ports 11-14.
• I/O (yellow) - 4 LEDs indicate that I/O channels 1-4 are active on Port 22
LCD display:
Liquid crystal display (2 lines with 20 characters per line) indicates current volume level and displays the Video,
Audio, and Status menus. See the
section on page 28 for details.
SWITCH pushbutton:
Press to access the Switch menu on the LCD display. Use the menu to choose to switch audio, video or both
from any input to any output.
TAKE pushbutton:
While in the Switch menu, press to implement an audio/video switch.
VIDEO MENU
pushbutton:
Press to access the Video menu on the LCD display. There are two video menus (VIDEO OUTPUT and VIDEO
INPUT) and both are accessible by using this button. Multiple presses cycle through the various VIDEO menus.