7
Lowes.com/harborbreeze
INITIAL INSTRUCTIONS
4. Remove hairpin clip (N) and clevis pin (M) from the
coupling (K) on motor housing (F). Retain for later use.
Note:
Make sure to keep loose hardware separate to
avoid confusion during installation.
Loosen the two coupling screws (O) in the coupling (K),
but do not remove them.
1. Place downrod assembly (B) through canopy (C), canopy
cover (D) and coupling cover (E). Then, feed power wires
from motor housing (F) through the downrod assembly (B).
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
C
E
D
B
1
F
3. Check existing outlet box (not included) to ensure it is
securely fastened to at least two points in a structural
ceiling member and can support the full weight of the
fan. Once verified, install mounting bracket (A) to the
outlet box using the screws and washers provided with
the outlet box.
Note:
If using the angel mount, make sure open end of
mounting bracket (A) is installed facing the higher point
of the ceiling.
DANGER:
A loose outlet box can cause the fan to wobble
and increase the fan's potential to fall, which could result
in serious injury or death.
3
Open End
A
A
4
M
O
N
K
F
For
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
,
proceed to Step 1 below. For
FLUSHMOUNT
INSTRUCTIONS
, skip to page 9.
