8
Lowes.com/harborbreeze
Proceed to
WIRING
on page 10.
DANGER:
Be careful when aligning the tab to the
notch! If not fully engaged, there is a possibility of the
fan falling, which may result in serious injury or death.
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
3. Cut off excess fixture wires, leaving approximately 6 to
9 inches above the top of the downrod assembly (B).
Strip 1/2 inch of insulation from the end each fixture wire.
4. Carefully lift the assembly and rest the hanger ball of
downrod assembly (B) on the mounting bracket (A)
attached to the outlet box. Be sure the groove in the
hanger ball is lined up with the tab on the mounting
bracket (A). This will allow for hands-free wiring.
6 to 9
in.
3
2. Insert downrod assembly (B) into the coupling (K).
Align the hole on downrod assembly (B) to hole on
coupling (K), then re-install clevis pin (M). Re-attach
hairpin clip (N) into clevis pin (M) until it snaps into
place, then tighten the two previously loosened
coupling screws (O).
B
N
M
F
O
2
A
B
4
Hanger
Ball
Tab
Slot
CAUTION:
Ensure all screws are tight before moving
onto the next step.
