11
FINAL INSTALLATION
Fan Pull Chain Slot
and Pull Chain
Locate motor screws (O) and 5.4 M/M lock washers
(P) that were removed in Step 4 on page 6.
Insert two motor screws (O), along with 5.4 M/M lock
washers (P), through one blade arm (G) to attach
blade arm (G) to motor. Tighten motor screws (O)
securely. (Fig. 3) Repeat with remaining blade arms
(G), making sure to completely secure each blade
arm (G) before proceeding with the next.
Note:
For easy access to motor screws (O), turn
switch housing plate so that the flat part of the switch
housing plate aligns with the two motor screws (O)
on blade arm (G).
Repeat Step 3 with remaining blade arms (G),
making sure to completely secure each blade arm
(G) before proceeding with the next.
3
3.
A
G
H
O
P
Switch
Housing
Plate
If you wish to USE the light kit
, remove three
screws from switch housing plate on underside of
motor. Locate
BLUE
(or
BLACK
) and
WHITE
wires
in switch housing plate labeled FOR LIGHT and
remove plastic from these two wires.
Connect
WHITE
wire from light kit fitter (E) to
WHITE
wire from switch housing plate. Connect
BLACK
wire from light kit fitter (E) to
BLUE
(or
BLACK
) wire from switch housing plate. Make sure
that molex connections are secure. (Fig. 4)
Continue with Step 5.
If you do NOT wish to use the light kit,
please go
to section entitled “Installing Fan Without Included
Light Kit” on page 13.
4
4.
Switch
Housing
Plate
Molex
Connections
A
E
Arrange wires and molex connections in switch
housing plate. Align fan pull chain slot with fan pull
chain and attach light kit fitter (E) to fan with screws
that were removed in the previous step. Use a Phillips
screwdriver to secure all three screws. (Fig. 5)
5
5.
A
E
Switch
Housing
Plate
