13
If you wish to use the fan with the light kit
,
remove the three preassembled switch housing cap
screws (N) from switch housing cap (M) located at
top of light kit fitter (F).
Locate the BLUE
(or BLACK) and WHITE molex
wires in the switch housing preassembled on motor
housing (D) that are labeled FOR LIGHT and
remove plastic from these two wires.
4.
N
M
F
N
2.
2
Partially insert three blade screws (BB) along with
three fiber blade washers (CC) into holes in blade
(G). Align pegs on blade arm (J) with blade screws
(BB), securing blade arm (J) to blade (G) by
tightening blade screws (BB) starting with the one in
the middle.
Repeat for remaining blades (G) and blade arms (J).
Hardware Used
Blade Screw
x 15
BB
Fiber Blade Washer
x 15
CC
CC
BB
G
J
Attach blade arms (J) to the bottom of motor
housing (D) with motor screws (S) and washers (T)
previously removed (Step 5, page 7). Tighten motor
screws (S) securely.
Note
: Make sure to completely secure each blade
arm (J) before proceeding to the next.
3.
3
D
G
J
If you do NOT wish to use the light kit
,
skip
to INSTALLING FAN WITHOUT LIGHT KIT on
page 16.
If you DO wish to use the light kit
, proceed to
Step 4.
4
D
Switch
Housing
White
Blue (or Black)
J
T
S
FINAL INSTALLATION
