8
DOWNROD-STYLE FAN MOUNTING
2. Insert downrod (A) through canopy (B) and yoke
cover (E). Then, thread wires from motor
housing (D) up through downrod (A).
2
B
A
3. Slip downrod (A) into yoke, align holes and
re-install pin (V) and clip (W). Tighten set screws
and then tighten nuts. Slide yoke cover (E) down
until it rests on top of motor housing (D).
Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested you do so in the
following manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the hanging ball on
the downrod and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included).
NOTE
: If you do
not
cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead
.
4.
Hanging
Ball
4
8 in.
E
D
A
V
E
3
W
V
Set Screw
and Nut
Sideview
Yoke
D
