14
FINAL INSTALLATION
5. Connect WHITE molex wire from switch housing to
WHITE molex wire from light kit fitter (F). Connect
BLUE
(or BLACK) molex wire from switch housing
to BLACK molex wire from light kit fitter (F). Make
sure molex connections are secure.
Then, align holes in switch housing cap (M) with
holes in switch housing.
Note:
Make sure to align
notch on top edge of the switch housing cap (M)
with the reverse switch on switch housing for the
correct fit.
Re-insert the switch housing screws (N) previously
removed (Step 4, page 13), then tighten all switch
housing cap screws (N) with a Phillips screwdriver
(not included).
Install bulbs (H).
CAUTION:
When replacing bulb(s), allow
bulb(s) and glass shade to cool down before
touching.
7
7.
H
H
Remove finial (O), finial plate (I), hex nut (K)
and rubber washer (Q) from the threaded rod
at the bottom of the light kit fitter (F). Save for
later use
.
6.
6
Threaded
Rod
O
I
Q
F
K
N
N
M
Notch
5
Molex
Connections
D
Switch
Housing
Reverse
Switch
