HappyJapan HCR3, Instruction Book

Page: 241 / 253

-R3 -57
24-5
ERRORS AND WHAT TO DO
24_5 Q101
1. Press .
2. Select “Auto”.
The main shaft turns 2 to 3 times and returns to
a stop position (“C” point ) automatically.
The display returns to drive mode.
What to do when Stop position of main shaft is out of place
(error E-050)
1. Press .
2. Select “Manual”.
The error status is released and the display
shows “drive mode”.
3. Remove the cap over the small hole in the
rear of the machine.
Using a 5mm wrench, Please turn the main
shaft and adjust it to the “C” point.
CAUTION! <Main shaft turns>
When you cannot clear by the method above (Auto)
E-050 C point
OK
E-050 C point
OK
C