EN
Haojue UF115 99011H5A001H000 V02 ES+EN+FR 2021-4-8 10:00
(109)
Tires
•
Inflate the tires to the pressure recommended in this
manual.
Exterior
•
Spray all rubber parts with a rubber protective agent.
•
Spray all paint-free surfaces with an anti-rust agent.
•
Coat the paint surface with vehicle wax.
Procedures for motorcycle re-service
•
Clean the motorcycle completely.
•
Re-install the battery.
NOTE: Connect the wire to the positive terminal first; then
the negative terminal.
•
Remove the spark plug.
Start the engine several
times, and then mount the spark plug.
•
Adjust tire pressure according to the instructions in the
tire section.
•
Lubricate
according
to
the
instructions
in
the
lubrication section.
•
Be sure to conduct necessary inspections according
to this manual before riding.
NOTICE OF THE FILLED BATTERY
USAGE
1. ACTIVATION OF THE FILLED BATTERY
1.1 * Checking before start using
1.1.1 Check outer appearance of the filled battery, make
sure that there is no bruise or cracks on the outer case,
there is no distortion or deformation of terminals, and clear
the surface of the filled battery.
1.1.2 Measure the terminal voltage of the filled battery.
If the votage is above 12.8V, the battery can be used
directly. If it is lower than 12.8V, it should be charged
before use.
1.2 Installation
1.2.1 Connect positive terminals “+” (with a red mark) first
and then negative terminals “-”.
Note: please note that
reversing the wires
can damage the electric components
such as the igniter device and the rectifier.
1.2.2 After tightening the bolts, apply grease or jelly to
bolts, nuts and terminals to prevent poor contact due to
rustiness.
2. USAGE AND MAINTENANCE
2.1 Each starting should not exceed 5 seconds. In case
starting is not effected, fuel supply, starting and ignition
systems should be checked.
2.2 The following cases shall result in excessive storage
battery discharging or insufficient charging and shall
shorten service life.
48
Haojue UF115 99011H5A001H000 V02 ES+EN+FR 2021-4-8 10:00
(109)
