English _
9
!
INST
ALLA
TION & CONNECTION
installation & connection
INSTALLATION
J
`
This camera is waterproof and in compliance with the IP67 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
~
Select an installation site that can hold at least 5 times the camera’s weight.
~
Stuck-in or peeled-off cables can cause damage to the product or a fire.
~
For safety purposes, keep anyone away from the installation site.
And put aside personal belongings from the site, just in case.
~
If the product is forcibly installed with excessive force, it may malfunction and damage the camera.
Forcing assembly using non-standard tools may damage the product.
Disassembling
1.
Separate it by loosening the fastening bolt at the bottom of the wall mount by turning it counterclockwise
using the supplied screwdriver bit.
4x
TR30
Installation (mount plate)
[If installing on a wall]
1-1.
Install the mount plate on the wall using the four provided anchor bolts.
M
`
When installing the camera on a wall, place the mount plate on the wall, drill a hole after marking the screw hole’s location,
then insert the anchor bolt for installation.
`
During installation, the side where ‘TOP (POLE)’ is engraved should face the wall. Also, install the product so that the arrow in
front, where ‘TOP (WALL)’ is engraved, faces the top, as shown in the figure.
1-2.
Take out the necessary cables from among the network/power/audio/alarm cables through the hole on
the mount plate.
M
`
This product can be connected to a 0.75” PF pipe depending on the installation conditions. There are three directions that the
pipe can be inserted from.
