installation & connection
10_
installation & connection
[If installing it on a pillar]
1-1.
Select the pillar for installation, and check the height for where you want to install the camera.
1-2.
Install the mount plate using a stainless steel mount strap (not supplied).
Stainless steel mount strap
(Optional accessory)
:SBP-100S
Mount plate
M
`
During installation, the side where ‘TOP (WALL)’ is engraved should face the wall. Also, install the product so that the arrow in
front, where ‘TOP (POLE)’ is engraved, faces the top, as shown in the figure.
`
When installing the camera on a pillar, connect it to the cable using the groove at the bottom of the mount plate.
Installation (installing cables)
2.
Remove all the cable bushings at the lower part of the wall mount.
[Installation of the network cable] (IP66)
3-1.
Take off the extruded part of the center hole at the cable bushing.
3-2.
Pass a RJ45 cable through the hole of the cable bushing with the provided cap installer.
Cap Installer
