Page EN-33
Installation, connection and initial commissioning
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
2. Loosen both screws on the reverse side
of the covering panel and remove them.
(37)
3. Affix the enclosed condensation protec-
tion film (37) to the underside of the work-
top. In this way, you will avoid damage to
the worktop caused by hot steam emitted
from the dishwasher when the appliance
door is left open.
4. Place the dishwasher in the desired po-
sition.
Inlet/outlet area and
electrical connection.
90°
600 mm
820 mm
100 mm
580 mm
80 mm
90°
Recess dimensions
