HANSCRAFT SPATOUCH 3, User Manual

Page: 4 / 36

4
Preparation for the installation of the hot tub
2 Preparation for the installation of
the hot tub
Check the hot tub before use! If any part of it is damaged or missing, immediately
contact the retailer without delay! Ensure that all components are in line with your
order Check the hot tub every time before use In case of any damage, do not use the
hot tub! In case your spa is equipped with screwless cabinet, it is prohibited to install
additional accessories or load the cabinet in a way not specified by the manufacturer.
Damage caused by failure to follow this precaution is not covered by the warranty!
2 1 Preparation of the place for installation and connection to
electricity
The hot tub must be installed on a flat, sufficiently solid base plate, taking into
account the load-bearing capacity of the building. If the hot tub is installed outdoors,
we recommend constructing a concrete monolithic base slab with a minimum
strength (thickness) of 10 cm. It is important to also always select the load-bearing
capacity of the base slab with regard to the dimensions and the weight of the hot tub.
Consult your building supervisor. The weight is specified in the technical description
of the given hot tub. The tubs are prepared by us for an electrical connection of
3× 230 V/400 V~ alternating current. Therefore, use a circuit breaker 3× 16 A/C or D,
alternatively 3× 20 A/C or D and a Residual Current protective Device corresponding
to this connection. Furthermore, it is necessary to have a cable with parameters
corresponding to the rightful regulations for this type of connection. The cable must
also have 4 usable meters at the location of the hot tub, so that it can be pulled
through and connected to the control unit without complications. Do not route the
cable under the hot tub!
Recommended Type C circuit breaker
Hot tubs with two massage motors: 3× 16 A/C or D
Hot tubs with three massage motors: 3× 20 A/C or D
!!!THE HOT TUB MUST ONLY BE CONNECTED BY A PERSON WITH PROFESSIONAL
ELECTRICAL QUALIFICATION IN ACCORDANCE WITH DECREE NO 50/1978 COLL !!!
NO YES