1
I. General rules
To keep the truck and you safe, obey these rules below:
1.
Only trained and authorized operators shall be permitted to operate the truck.
2.
Before starting truck you should check all control and alarm devices; if any are damaged, DO
NOT operate until it is repaired.
3.
When carrying a load, do not overload. The forks should insert in the load completely and evenly.
It is not permitted use only one fork to load.
4.
You should operate the truck smoothly when starting, turning, traveling, braking and parking. On
a slick or wet road, decrease speed when turning.
5.
Lower the forks and tilt the mast backwards when traveling with a load.
6.
If the slope angle is bigger than 10%, travel forward up slope and backward down slope. Never
turn sideways or stack load on an incline.
7.
Be aware of bystanders, barriers, potholes and overhead clearances.
8.
DO NOT allow passengers or persons to stand on the fork.
9.
DO NOT stand or walk under the fork.
10.
DO NOT operate the truck or attachment from any position except the operator‘s seat.
11.
DO NOT carry the load unpackaged. Be careful when carrying large loads.
12.
Take care not to lose load when lift height is higher than 3 meters, take protective measures if
necessary.
13.
Travel with load as low as possible and tilt back the mast.
14.
When driving over a dock-board or bridge-plate, be careful and drive slowly.
15.
Make sure that there is no naked flame near the area, never smoke. The driver should not
remain seated when adding fuel.
16.
Treat the truck with attachments as a loaded truck
17. When leave the truck, you should put the forks down, make the shift lever in neutral, shut down
the engine and cut the power. When parking on a grade, make sure to tighten the brake lever. If
necessary, use a block when parking on a grade for a long time.
18. If the truck suddenly gets out of order, or for leakage of electrolyte, hydraulic oil or brake oil
when lifting goods or grade climbing, leave truck in safe state and contact service technician
immediately.
19. During installation and assembly, there will be noise and vibration. Please choose the right tool
and assembly method. Minimize the noise and vibration as soon as possible to reduce noise
pollution.
20. The work road surface for forklift should be stable and free of litter, preferably cement, blacktop
or concrete. If there is snow, ice, water or other eye irritants, protect against these and resume
work.
21. Move the truck to the place where respects traffic when it anchors. If the reason is brake or turn
system, move it by a suitable truck (Refer to the part of truck carrying); other reasons, use a
suitable truck to move, tie the cord outside of truck. Please abide by the traffic regulations when
moving the truck on roads.
22. DO NOT operate the truck or load cargo after removing the hood, water tank cover board,
overhead guard, or load backrest of mast.
23. Make sure there is enough light around the work area. At night, use the head lamps.
24. Handle with automatic pitch fork of the forklift when the load must not make lateral operation, so
as not to lose balance and forklift components of the damage caused.
25. 5-10 t trucks are equipped with energy accumulator, which offers at least one time emergency
braking after engine off. In order to ensure your safety, please carefully read and strictly carry out
relevant accumulator operation.
26. Before hydraulic oil temperature rises, do not tilt the mast forward, backward or lift the mast to
the limit when in idling.
27. No modifications or alterations to a powered industrial truck, which could affect, for example,
capacity, stability or safety requirements of the truck, shall be made without the prior written
approval of the original truck manufacturer, its authorized representative, or a successor thereof.
