35
position, and shut off engine.
Warning
Hot hydraulic oil and parts will cause injury.
DO NOT touch the hot hydraulic oil and
parts
①
Put one case (volume is over 20 liters)
under the transmission.
②
Remove oil plug and drain oil.
③
Clean oil plug then install.
④
Take out the dipstick. Add hydraulic oil.
See
Table for the oil used in the truck
, and
then install dipstick.
⑤
Startup engine. Step the brake pedal,
get the engine idle running, place the
transmission in forward and backward so that
the oil enters the clutch.
⑥
Place transmission in neutral, apply
parking brake.
⑦
Take out the dipstick, inspect fluid
position. If oil is not enough, add oil to keep it
between max and mix marks
。
⑧
Check the filter and oil plug for leaks.
⑨
Shut off engine, install front soleplate.
6. Air-bleeding fuel system [Diesel]
During fueling or draining water from
separator, it‘s also necessary to bleed air in
the fuel system.
①
Loosen the bleed plug;
②
Press the priming pump until fuel comes
through the bleed plug without any bubbles;
③
Fasten the bleed plug;
7. Oil-water separator draining [Diesel]
Except
Cummins Diesel
：
①
Position an approved container under the
fuel filter to collect the contaminants.
②
Loosen the drain cock (2) at the bottom of
the fuel filter Drain any water collected
inside.
③
Hand tighten the drain cock.
④
Be sure to prime the diesel fuel system
when you are done.
Cummins Diesel
：
Can type
：
①
Shut the engine;
②
Place a container under the fuel filter;
③
Uplift the drain valve control rod until
the liquid is completely drained and see clean
fuel;
④
Push up drain rod until the liquid is
completely drained.
Rotary type
：
①
Shut the engine
；
②
Place a container under the fuel filter
；
③
Open the drain valve. Turn the valve
3.5 rings counterclockwise, until the valve
drop 25.4mm and start to drain;
④
Drain the water in the separator until
see the clean fuel.
Caution
Do not screw the valve too tight when shutting
the drain valve. Over tightening will damage
thread. When shutting the valve, uplift the
valve and rotate in clockwise until screw
down.
8. Exhaust gas check
