8
Engine oil pressure alert lamp
（
K
）
This lamp indicates the pressure condition of
engine lube oil. Although it lights up when the
engine switch is set at ―ON‖, once the engine
starts up and the accelerator pedal is pressed,
this lamp goes out.
Caution
If this light continues to stay lit or lights up
during operation, the pressure is lower than
0.05Mpa
and
should
be
checked
immediately.
Charging indicator (L)
This lamp indicates the battery condition of
charge. The lamp comes on when the ignition
switch is set at
┃
―ON‖, but it goes out as the
engine starts and accelerator pedal is
pressed.
Caution
If the light continues to stay lit or lights up
during operation, the charging rate is low
and should be checked immediately.
Left turning indicator [M]
Right turning indicator [N]
When the truck turns left, the indicator is set
forward, the lamp lights up.
When the truck turns right, the indicator is set
backward, the lamp lights up.
Air filter indicator [O]
When the light is on, it indicates the air inlet
system is blocked, stop the truck and clean
the air filter.
Engine fault indicator [P]
[Electronic-controlled engine]
1.0t-3.5t(Except W43 Cummins engine): This
indicator does not work.
4.0t-7.0t
：
PSI engine f
orklift truck: When the
engine gets out of order, this Indicator will
be on. Please stop and eliminate the failure.
Only Cummins engine forklift truck :
When this light is on, it means one important
engine working is beyond the prescribed
limits of engine protection calibration, engine
power can be reduced, you must stop and
check.
Severe warning indicator [Q]
[Electronic-controlled engine]
Only Cummins engine forklift truck:
When this light is on, it indicates the engine is
in severe work condition and the engine
power reduced severely. If condition stays
and starts engine protection shut-down, then
this indicator will flash 30 seconds before
engine shut down to warn the impending
shut-down.
