56
2) Inspect the charger before charging to ensure correct wiring and no faults or abnormalities.
3) Confirm the battery voltage and capacity match the charger. (Refer to charger specs and battery specs).
4) Before charging, connect the charger output plug to the truck battery socket, and then connect the
charger input plug to the power socket.
5) If there are no faults, the charger will receive the charging command (including charging voltage,
charging current, start-up instructions, etc.) from the truck battery BMS and automatically start charging
the battery, and the indicator light will blink.
6) If an error occurs during charging, press "Pause" to stop charging until the fault is resolved.
7) After the battery is fully charged, the charger will automatically stop charging and the indicator light
will be on.
8) If the truck needs to be used before charging is complete, press "Pause" to stop charging and then
disconnect the plugs.
9) During charging, the indicator light blinks. The display sequentially shows the following 4 screens:
Current settings: Current set value sent by battery BMS to
charger
Voltage settings: Voltage set value sent by battery BMS to
charger
Voltage during charging: Battery current voltage value
Battery temperature: Battery temperature during charging
Max. voltage:
Highest single cell voltage in battery pack
Battery SOC: Battery's current SOC value
Module A current: Charger module A output current value
Module B current: Charger module B output current value
Module C current: Charger module C output current value
