55
Dimension
1028 mm×710 mm×780 mm
CAUTION
The box must be pulled up with
using 4 holes of the pothook at the
same time. It is not allowed to pull
up with only two holes. Otherwise,
the asymmetric power will cause the
battery damaged.
The steering wheel and other
equipment should not be bumped,
avoid being damaged when pulling
up the battery box.
when you lift the battery side-on
，
you need to keep it stable and lift it
slowly
，
to avoid hitting against the
forklift which will break the battery.
–
After exchange the full electricity of
battery, plug into the lock pin, shut to the
hood cover, and plug into the pin of the
battery hard.
The waste electrolyte of the replaced
battery should be dealt according to
environment and protection law rather
than reject at will.
The
proportion
and
level
of
electrolyte
CAUTION
If the level of the electrolyte is low,
using the battery will cause the
battery over-heat and shorten the
battery’s life.
1. Inspect electrolyte
The battery without a dobber
It is proper to pour the electrolyte 15-20mm
above the electrode plate.
The battery with a dobber
Depending on the dobber of the winded cover,
and read the level position of the electrolyte.
2. Replenish the distilled water
Wear the blinkers, rubber overshoes and
rubber glove.
–
Using the measuring cylinder to take out
the distilled water with a certain quantity.
–
Open the battery cover for every battery
cell.
–
Imbibe distilled water with injector and then
supply it into the battery.
The battery with a dobber
When the red dobber rises, the white line is
appeared, please stop to replenish the distilled
water.
