15
CAUTION
When replace a new fuse, please
choose the same capacity fuse of
the old one.
Fork stopper [31]
Fork stoppers are locked the forks in position.
To adjust fork spacing, pull up fork stoppers,
turn 90°and shift the forks to the desired
position. The fork spacing should be adjusting
according to loads to be handled.
WARNING
The
forks
should
be
set
symmetrically to machine centerline
and fork stoppers should always be
locked again.
There are one gap on the below
beam. It is used to attach goods.
It is forbidden to lock the fork on the
gap position, to prevent the fork fall
off from the gap.
In the middle of the above beam, a
bolt used to prevent fork works
here. Please change the bolt as
soon as it is damaged.
Change fork
Take down the old fork: Firstly, locate the fork
to the middle, decline it to the ground and
make the mast forward, then operate the truck
traveling backward, the fork will be taken
down.
Change new fork: Firstly, make the fork dead
against the truck and forklift‟s mast to the
bottom, then operate the truck traveling
forward, aim at the two gaps and beams, and
raise the mast. Adjust the position of the fork.
Battery cover hood
The cover hood can be swung up fully to
provide easy examining and maintenance of
the storage batteries.
You can lift up the cover hood with little effort
with an aid of cover hood damper. To lock the
cover hood, push down on the front of cover
hood until it covered.
CAUTION
Be careful do not to catch you
fingers in the cover hood when
closing it.
Depress
the
spring
insurance
before you close the cover hood,
then press the head of the cover
hood.
Overhead guard
The overhead guard used is strong enough to
