Main wing joiner(20x420mm)
TP Screw (3x20mm)
TP Screw (3x20mm) 8
8
TP Screw (2.3x12mm)
TP Screw (2.3x12mm)
Assemble the retracts to the appropriate position
in the gear house.
Connect the two wings through the main wing joiners.
The sketch map of the wing fits well to the fuselage.
Drag the servo line and retracts lines from the wing.
4
Main wing joiner(20x420mm)
Factory already set blind nuts in the wings, the customers can
fix the wing to the fuselage by tightening the nylon screws.
2
Screw (6x50mm)
Screw (6x50mm)
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
The sketch map should be when the stabilizer
assembly completion.
17
18
20
21
4
16
19
1
Linkage Stopper
2
Plastic tube (2x650mm)
Fuel tank (550cc)
1
5
Screw (3x10mm)
5
Washer(3x6mm)
Tail wheel servo
Rudder servo
Rudder servo
TP Screw (2.3x8mm)
1.5mm
4
TP Screw (2.3x8mm)
163mm
The sketch map of the steel wires working in
the fuselage.
The sketch map of the steel wires connection out
of the fuselage.
Take off the tail wheel and trim a slot on the tail
cover for assembling the tail wheel.
The side view when the engine install completion.
Assemble the tail
gear
cover with screws as below.
45
44
46
47
9
48
Accessory list for the coming installation steps.
