Tail wheel (45mm)
Collar
Screw (2.6x12mm)
3
Screw (2.6x12mm)
Steel wire (0.5x3000mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Aluminum tube
Install the servo.
4
4
Clevis
Copper joiner
4
4
Screw (2x10mm)
4
Washer(2x5mm)
4
Steel wire (0.5x3000mm)
4
Aluminum tube
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
2
Washer(2x5mm)
2
Steel wire (0.5x3000mm)
2
Aluminum tube
Alu clevis
Locknut (2mm )
Locknut (2mm )
The sketch map when assemble the tail landing
gear to the wheel steeling mount.
The sketch map of the tail wheel and steel wires
working in the fuselage.
Fix the tail gear to the tail fuselage.
Assemble the steel wires well to the rudder horn
and tail wheel.
Connect the steel wires of the rudder horn and
tail gear to the servo.
39
41
42
43
8
40
38
2
carbon fiber tube(10x285mm)
1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Elevator
Apply instant type AB glue to elevator and hinges.
Keep some space about 1mm width between
elevator and tailing edge.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Epoxy the elevator to the stabilizer.
Fix the carbon fiber tube to one side of the stab
with screws.
Glue the wooden block to each side of the stab tube as below, put the stab
tube into one side the horizontal to the end and mark it out at the root of
the horizontal, drill a hole in the stab tube and horizontal as illustration.
Make sure hinges are
mounted in the same line.
5mm
5mm
15mm
15mm
1.5mm
Screw (2.6x12mm)
1
1
Washer(3x10mm)
3mm
Screw (2.6x12mm)
Washer(3x10mm)
Screw (2.6x12mm)
2
2
Washer(3x10mm)
9
carbon fiber tube(10x285mm)
Horn
4
pivot & round hinge(5x68mm)
6
pivot & round hinge(5x68mm)
22
24
23
25
5
26
Accessory list for the coming installation steps.
