B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
Screw (2.6x12mm)
Washer(3x10mm)
1.5mm
Screw (2.6x12mm)
1
1
Washer(3x10mm)
3mm
Make sure hinges are
mounted in the same line.
3
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Horn
4
pivot & round hinge(5x68mm)
The sketch map should be when the stabilizer
assembly completion.
Assemble the stab to the fuselage drill a hole to
the other section stab.
Fix the other side of the stab with screw.
Epoxy the pivot & round hinges to the rudder.
Epoxy the rudder to the vertical fin.
Epoxy the fiber horns to the slots in the rudder
and elevator.
27
28
29
30
32
6
31
8
Clevis(2mm)
Lock Nut (2mm )
Screw (2x10mm)
Washer(2x5mm)
2
2
Screw (2x10mm)
2
Washer(2x5mm)
1
EVA(10mm)
EVA(10mm)
1
EVA(10mm)
Assemble the servos.
The sketch map of the push rod connect to the
elevator servo.
Assemble the push rod branches to the horns on
the elevator.
Assemble the another side of the push rod to the
elevator servo in the fuselage as image.
The sketch map of the push rod working in the fuselage.
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Nut (2mm)
Set screw (3x4mm)
Set screw (3x4mm)
1
1
1
1
4
Steel wire (0.5x3000mm)
8
8
8
8
Copper joiner
Screw (2x10mm)
Washer(2x5mm)
1
Push rod
Set screw (3x4mm)
Washer (2mm)
Nut (2mm)
8
Aluminum tube
Linkage Stopper
1
3
TP Screw (2.6x12mm )
4
TP Screw (2.3x8mm)
1
Tail wheel (45mm)
1
Tail gear
1
Alu clevis
2mm Rod
Adjustable Rod
Adjustable Rod
Lock Nut (2mm )
Screw (2x10mm)
Washer(2x5mm)
Push rod
Locknut (2mm )
Locknut (2mm )
34
35
36
37
7
33
Accessory list for the coming installation steps.
