30
Step 11
Move the carburetor to the half-throttle position.
Mark the pushrod where it crosses the throttle
arm using a felt-tipped pen. Remove the
pushrod and make a “Z” bend in pushrod.
Step 12
Remove the clevis from the pushrod. Slide
the pushrod into the pushrod tube from the
firewall. Attach the “Z” bend to throttle arm.
Step 13
Thread the clevis back onto pushrod. Attach the clevis to
the throttle arm. Move the throttle to full throttle using the
radio. Check the carburetor to make sure it is fully open.
Adjust the clevis to correspond full throttle on the radio to
full throttle on the carburetor. Use the radio to check low
for idle and closed. Move the linkage at the carburetor arm
and servo arm as necessary for full range of operation.
Step 14
Locate the fuel tank. Determine which fuel line is the
vent line by looking at the top of the fuel tank. Make
a note as to which side the vent line is located.
Note
: The stopper on the tank is
towards the top of the tank.
Step 15
Glue a strip of 1/4" (6mm) foam onto the
fuel tank support. Use two rubber bands
to secure the fuel tank in position.
Step 16
Attach the muffler to the engine. Make the
proper connections to the engine using the
engine manufacturer’s instructions.
Section 7: Engine Installation
Summary of Contents for FuntanaX 100 ARF
Page 40: ...40 Notes ...
Page 41: ...41 Notes ...
