22
Step 6
Remove the rudder from the fin. Use the mark from the
last step to locate the control horn. Use a felt-tipped
pen to mark the locations for the control horn. Drill the
locations using a 3/32" (2.5mm) drill bit. Harden the
holes using thin CA. Attach the control horn using three
2mm x 16mm screws and the control horn backplate.
Step 7
Make a mark 1" (25mm) from the bottom of the rudder.
Drill the location using a 1/8" (3mm) drill bit. Make sure
the drill is perpendicular to the hinge line of the rudder.
Step 8
Cut a groove from the hole to the bottom
of the rudder. This is necessary to provide
clearance for the tail wheel bearing.
Hint
: An 11/64" (4.5mm) drill bit can be
used to size the notch perfectly to the nylon
bushing of the tail wheel assembly.
Step 9
Test fit the tail wheel bracket into the rudder.
Make sure there is plenty of clearance for the
bracket bushing and the hole has been drilled
deep enough to fit the tail wheel wire.
Section 5: Rudder Installation
Summary of Contents for FuntanaX 100 ARF
Page 40: ...40 Notes ...
Page 41: ...41 Notes ...
