13
Required Parts
• Wing panel (right and left) • Fuselage
• 1/4-20 x 2" nylon bolt (2) • Wing tube
• Anti-rotation pin (2)
• Wing fillet (right and left)
Required Tools and Adhesives
• 6-minute epoxy
• Epoxy brush
• Masking tape
Step 1
Locate an anti-rotation pin and test fit it into one
of the wing panels. The pin should extend roughly
3/4" (19mm) from the edge of the wing. Once
satisfied with the fit, rough the tube using sandpaper
then glue it into the wing using 6-minute epoxy.
The tube must be glued securely into the wing.
Step 2
Cut a piece of the plastic packaging and tape it
to the side of the fuselage in the location of the
wing fillet attachment. This will prevent getting
epoxy on the fuselage in later steps, and gluing the
wing and/or fillet to the fuselage by accident.
Step 3
Locate the wing tube and carefully slide it into
one wing panel. Slide the wing (with tube) into
the wing tube opening in the fuselage.
Section 2: Wing Installation
Summary of Contents for FuntanaX 100 ARF
Page 40: ...40 Notes ...
Page 41: ...41 Notes ...
