H&S 2957, Operator'S Manual

Page: 23 / 50

4.6 Attaching/Unhooking
The drawbar of the Bale Processor is equipped with a two piece clevis style hitch. If the tractor is
equipped with a clevis hitch, the clevis portion of the Bale Processor must be removed to prevent
binding when operating on uneven terrain.
Check hitch and clevis bolts on a weekly basis to make sure that they are properly tightened.
The machine should always be parked on a level, dry area that is free of debris and foreign objects.
Follow this procedure when attaching processor to tractor:
1. Clear the area of bystanders and remove foreign objects from the machine and working area.
2. Adjust the length of the drawbar to give the appropriate dimensions between the PTO shaft and the
drawbar pin hole (Refer to Tractor Operator’s Manual).
3. Use the jack to raise or lower the hitch to align with the drawbar.
4. Make sure there is enough room to back the tractor up to the hitch.
5. Start the tractor and slowly back it up to the hitch.
6. Stop the tractor engine, place all controls in neutral, set the parking brake and remove the ignition key
before dismounting.
7. Install a drawbar pin with provisions for a mechanical retainer such as a Klick pin. Install the retainer.
8. Attach the safety chain between the machine and the tractor drawbar cage.
-
4.6
-