H&S 2957, Operator'S Manual

Page: 45 / 50

-
8
.
2
-
8
.1 Hydraulic Deflector Kit Installation
4) Install the second cylinder mounting pin
(3
-
1/4”), secure with 3/8” bolt, washer, and
lock nut.
5) Extend the cylinder to its maximum point of
extension, making sure that the deflector
shield does not come closer than 1” away from
contacting the bale shroud.
6)
After making sure the deflector shield is free
to move without hitting the bale shroud, retract
the cylinder until it is closed. Watch to make
sure that cylinder does not put excessive
pressure upwards on the deflector shield in
this position.
If there is excessive pressure on the deflector shield, loosen the bolts holding the
top cylinder mount, and adjust its position down slightly within the slotted holes.
After adjusting the top cylinder mount, recheck that the deflector does not come
closer than 1” away from contacting the bale shroud. Further adjustment is
available by positioning the table and support brackets as necessary.