H&S 2957, Operator'S Manual

Page: 26 / 50

6) At this time a second bale can be picked
up on the forks and brought along to the
feeding area if desired.
Important: When the second bale is loaded
on the bale tines, make sure that the loaded
bale does not interfere with the cradle
operation. Interference can cause damage to
the cradle.
7) Processing:
a. Set the discharge deflector to the
desired position.
b. Start the tractor and run on idle.
c. Drive to the desired unloading location.
d. With the tractor on idle, slowly engage
PTO.
e. Increase engine RPM to rated PTO
speed.
f.
Engage rocking bale cradle hydrau-
lic circuit.
IMPORTANT
The processor is equipped with an 80º constant
velocity drive line. When operating the Bale
Processor, keep the PTO drive line as straight
as possible to have the universal joint angles
as small as possible during operation. Avoid
sharp turns with the PTO engaged. If a sharp
turn is unavoidable, disengage the PTO for the
turn and then re
-
engage when appropriate to
do so. Operating at more than 80º will damage
the CV joint and will void warranty.
-
4.9
-
4.7.1 Loading and Processing