MAINTENANCE AND TROUBLESHOOTING
-
Ⅳ
-
4. Setting of welding current and voltage
1) Press the ENTER key to enter the welding interface shown below:
2) In the welding interface, rotate L Knob to set the welding current, for which the adjustable
scope is different with the welding wires and gases as described in §4.3;
3) The welding voltage will be automatically set as the value corresponding to that of the
welding current set by rotating L Knob.
4) When the programmed welding current does not meet user requirements, the setting is
available by rotating R Knob;
5) After the setting, press L Knob and R Knob for confirmation;
§4.2.2Operation of the MIG/MAG Manual welding method:
1. Selection of the welding method:
1) In the main interface, press the MENU key to enter the function selection interface;
2) In the function selection interface, rotate L Knob to select the MIG/MAG Manual welding
method and press down it for confirmation as shown in Fig. 1;
3) In the wire cabinet, confirm “Selection Switch” is turn down to activate wire feed drive.