H&S AUTOSHOT HSM200, Operator'S Manual, Page: 15 / 25

MAINTENANCE AND TROUBLESHOOTING
- Ⅳ -
2. Selection and setting of welding parameters:
1) In the main interface, press the MENU key to enter the welding parameter setting interface;
2) In the welding parameter setting interface, rotate L Knob to select the parameter as
required and rotate R Knob to set a value for the parameter, afterwards, press L Knob or R
Knob for confirmation. Refer to Fig. 2;
3. Setting of wire feed rate and welding current:
1) Press the ENTER key to enter the welding interface shown below:
2) In the welding interface, rotate L Knob to set the wire feed rate (1.5 - 13.0 m/min) and
rotate R Knob to set the welding current (10 - 27 V);
3) After the settings, press L Knob and R Knob for confirmation;
4. Selecting spool gun operation:
1) Install spool gun into Gun socket and set Switch to “Spool Gun”.