Handicare TROPHY 20, Service Manual

Page: 80 / 99

Trophy 20 80 | Service instructions 80 | Service instructions
Mount the foot throttle
Preparation
• Switch off the scooter with the ignition key.
• Disconnect the batteries.
Instructions
Note!
This procedure is intended for the Throphy 20
with the latest electronics. In case your Trophy 20 has
the dashboard as above, you have the latest version
electronics. Contact Handicare in case you have the
following dashboard (older version electronics).
The following operations are required to mount the foot
throttle:
Note!
Suitable work area required!
Note!
Remove always one fi nger-control! Replace it with
cover steering wheel 9007423.
• Loosen
the fl oor mat from the frame.
Note!
For mounting the foot throttle on the fl oor mat you
have to drill two holes in the fl oor mat and frame. Be
sure you will not damage any cables mounted under the
frame!
• Determine the exact laying of the cables under the
frame.
• Reposition the cables in case they will be damaged
while drilling the two holes.
• Replace the fl oor mat and position the foot throttle
mounting plate on the fl oor mat.
• Drill the holes and mount the foot throttle mounting plate.
• Mount the foot throttle on the mounting plate.
• Guide the cable trough and under the frame, to the
electronics compartment on the backside of the scooter.
• Remove the rear cover.
• Connect the plug to the socket in the electronics
compartment and replace the rear cover.
Relevant article numbers
• 9007083 Foot throttle Advanced electronics
• 1008730 4,8x19 self tapping screw
Tools used
• Allen key, 3 mm
• Metal drill, 6 mm
• Drill
• Screwdriver,
crosshead
1
110948-03-018
Determine the exact laying of the cables under the frame.
Note! Reposition the cables in case they will be damaged
while drilling the two holes.
2
110948-03-019